300x300mm Spring Steel Sheet +PEI+Magnet For Becoming Magnetic Hot Bed Build Surface Plate CR-10S Lulzbot | Компьютеры и офис

---

300x300mm Spring Steel Sheet +PEI+Magnet For Becoming Magnetic Hot Bed Build Surface Plate For CR-10S Lulzbot

Sprint Steel Sheet:   Never warp& Never rust. Easy to get the first layer even for a new user Flexible, Removable, stick to magnets very well Suits variety of filaments, especially for PLA and ABS Free clean- just flex the plate a little then take the prints off after cooled Fast heater performance, less waiting time after printing. A lifetime 3D printer bed   How to use?   Step 1: take 1pc ordinary hot bed, 9 pcs magnets, 9 pcs of 3M Adhesive,9pcs temperature resistant tape
Step 2: Take a piece of magnet, stick 3M Adhesive to tear off the back, and then stick it on the corner of the hot bed.Finally,stick the temperature resistant tape.
Step 3: According to the second step, put all the nine magnets in turn.
Note: 1.When attaching the magnet to the hot bed, do not stick it on the screw hole.
2.If you install a magnet that will hit the 100K ohm thermistors of hot bed , you can move the thermistors aside.     Package includes: ​ Type1: 9*Magnets 9*3M Adhesive 9*temperature resistant tape   Type 2: 9*Magnets 9*3M Adhesive 9*temperature resistant tape 1*spring steel sheet   Type 3: 9*Magnets 9*3M Adhesive 9*temperature resistant tape 1*spring steel sheet 1*pei