---

 

Note:RW-4P comes without controller.

Specificatios Volt: 110~240v  Freq: 50/60Hz  Power: 10W Water flow: 500-4000L/hour (adjustable)    Note:   The "wireless" does not means that this pump doesn't need to be connected with electricity cable and control pad. This pump still needs to connect with electricity cable and control pad. If two of this wave makers works together, the two pumps can be wireless controled as "master" and "slave" wave maker, there is no need to connect the two wave maker together.    Features:   8 Different Flow Rate  Super Silent. The Rubber is Base on FS Series to Design (100% smaller sound than Vortech)  Wireless Controller to connect Master / Slave Pump  Can Standalone Operation on One Pump or Wireless  Easy installation and maintenance.  Magnetic bracket  One-touch feed mode - slows pump for a period of 10 minutes.  High performance, powerful, water flow combined with low energy consumption.  Ceramic shaft for long life and durability  Intelligent control system to generate various wave patterns to suit your tank.    Wave Mode:    W1:Wave Mode    Remoting the knob is necessary when operate this mode to adjust the wave patterns among one or more pumps at the same time. As the volum of water in tank is different from the capacity of the tank, wave period needed to be adjusted by switching the knob. The wave is biggest when wave length turn to be same as the length of tank; Increase the wave length by switching the knob in clockwise, and reduce in anti clockwise.    Tips: You should switch the knob gradually and notice the wave pattern in a certain period after each adjustment.Press “SPEED/FEED”to adjust the flow rate.    W2: Sine Mode       One or more pumps can operate at the same time in this mode. The power various between 30%-100% and the regulation looks like a sine curve.    Else: Random Mode    One or more pumps can operate at the same time. It is a random mode as the power of pump is changing to a random data all the time without regulation.    H:Flow Mode    One or more pumps can operate at the same time. In constant flow. Flow rate can be adjusted by “SPEED/FEED”    C: Shift to flow mode     Two pumps are needed to be operated at the same time, when they shift wave and flow in cycles. P1 work, P2 stop;P2 work, P1 stop;P1 work, P2 stop. and cycles like this. Cycle period (1s-1min) can by adjusted by switching the knob and adjust the flow rate by pressing SPEED/FEED     

Click to check more models

TC-4A

TC-5A

TC-6A

WP-10 WP-10P

WP-25 WP-25P

WP-40 WP-40P

WP-60 WP-60P

RW-4 RW-4P

RW-8 RW-8P

RW-15 RW-15P

RW-20 RW-20P